Anycubic Photon Printer Owners 造訪社團

So this is a new one, I can't seem to level because my photon bottoms out and skips steps before the build plate is close enough. it's so cramped back there I can't see what is getting stuck first, but whatever it is it's def lower than it used to be... anyone else go through this?

翻譯年糕

1.) Is that "snap" of the resin pulling off the FEP between layers a good sign or a bad one? I mean, I'll know for sure in 23 hours but I can't remember. :)

2.) Do you guys sand your build platforms? I thought I had seen a few recommendations to do that.

翻譯年糕

Trying to figure out where to vent fumes into the air purifier. I found a couple different ones. One that replaces the window in the top of the unit and one that replaces the back vent area. Anyone know which is most effective?

翻譯年糕

Hey everybody! So does anyone have any experience with mixing different color resins (same brand) to create new colors? i.e. monocure 3d rapid red and white to make *pink*

翻譯年糕

Well, it looks like I need to contact support. This explains a lot why one side of my prints is always missing supports and has a lot of scarring on the print.

I hope it doesn't take weeks like others are experiencing.

Alan Ruan
Amy Liao

翻譯年糕

Hello folks. I just ordered my Photon. Can't wait! I've been using a Sparkmaker and decided I wanted something... better.

翻譯年糕

Resin pump coming along nicely. Redesigned the main body and added covers for the motor and separate electronics enclosure

翻譯年糕

New print. I'still amazed with the low thickness This thing can print!

翻譯年糕

is there any good alternative to IPA please is there any good alternative to IPA please 翻譯年糕

Hi Expert Photon Users

I've just had a go at printing in Senertek resin and I'm happy with the resolution, The claws of this ring are meant to be 1.2 mm in thickness but are measuring only 1.04 mm after the print, how are other photon users accommodating shrinkage of the resins?

Would I just scale the object up in the Photon Slicer Program? Or I would need to draw the object to scale but thicker to accommodate? Happy for any suggestions

翻譯年糕