Anycubic Photon Printer Owners 造訪社團

Hi mates. I'm a new owner of a photon but i failed two print in a row. Is the 2k dlp working properly?
I'll try again tomorrow with the levelling guide i found in this group!

翻譯年糕

I just got my photon out of the box today. I need a few questions answered.

1. I have heard if a way to limit the smell with some kind of charcoal filter.
Does anyone have any more information on that?

2. Do the blue panels on the sides of the machine block UV Rays?

3. What is the best way to make a UV curig chamber?
The ones on amazon are kinda pricey and I am sure there is a cheaper DIY option.

4. Is there a better slicer than the stock one?

翻譯年糕

Hello group.
I have been following you for a few days and read many of the posts to acquire information about the Photon.
I would like to buy it in the next days to make prints and then silicone molds for a small production of figures i already made for 3D artworks.

I'm ok on the photon but still undecided about the type of resin. The translucency is not a prerogative because I would still cast them. That said, non-castable resins still works for silicon molds right? Which resin do you recommend in general to start for "print, then silicon mold, then casting" and which material then for casting itself?
Sorry for long post and bad english, hope you can help me.

翻譯年糕

What setting to I need to adjust to fix this sort of delamination I see on the bottoms of models sometimes? Is it bad supports, or a exposure setting? I used autosupport for this one and there is a lot of warping in the center and the layers separating on some of the heavier edges.

I have it set to bottom exposure 60, 8 layers.

翻譯年糕

Well my UV light finally arrived after 2 months of waiting... Should work nicely though ?

翻譯年糕

Hi everybody,
Here is my first print with the awesome Anycubic Photon!

翻譯年糕

Not really understand why arm's are flat!

翻譯年糕

Hi, i like the idea printing "technical" things parallel to XYZ axis, the sloped print causes disturbing layer artifacts. The problem i am facing is the first layer. My first layer is always 0,4mm thick. Is there a way to control the first layer thickness? I will by happy if it is no more than 0,1mm (I believe my printer is well calibrated)
The second problem are bubbles, time to time i am finding bubbles (holes) in the print, I guess the bubbles are coming from resin. How to avoid bubbles?

翻譯年糕

Hey all! I've found a fantastic resin which prints as well as the Anycubic and it's cheap! Yay! I'll be putting up a quick review video later today on it and I'm trying hard not to talk poorly about 3dOkay resin in it. I refer to not bullshit in my videos. Keep the 3dOkay commentary, or cut it?

翻譯年糕

Ring. My first print (well, actually second one if you consider the Anycubic test cube). Must admit. I'm quite impressed!

翻譯年糕