Anycubic Photon Printer Owners 造訪社團

hey

i printed a full plate model for about 9-10 hours.

the print was perfectly printed, exept of the last 10% (after i woke up in the morning) it seems like the plattform it way to high for that position of printing.

and after i stoped the print at 90% it also crashed at the maximum highed and kind of making that sound like it cant move higher.

what can that be? sounds like a software problem.

thank you

m

翻譯年糕

Casted this pendant out of sterling silver for my mom’s Mothers Day gift.

翻譯年糕

A couple of other pieces for Star Wars Legion, or really any sci-fi/modern game. Corvus Games Terrain has released a set of greebles. Unfortunately, I don't think my bed was totally level, since a few on one side did not print. *sigh*. These look really good.

Now, I need to figure out why my printer quit moving the Z rod. *sigh* :-( At least the print finished before it decided to have some problems!

翻譯年糕

Just printed my first successful print. HeroForge miniature. I need to invest in some grey or white resin. Turned out nicely I think.

翻譯年糕

ugh this is driving me nuts! I got my printer Monday and still don't have it set up. Work got busy and I didn't have time to work on rearranging my office/shop/man cave. I finally have the new TV stand together and 4K set back up. Now I just need to straighten up the mess I made and finish where I am going to set the printer (for now). HOPEFULLY tomorrow I'll be printing! :)

翻譯年糕

I have zero control over airbrush...Too little paint came out. pull back, too much came out. let go abit, too little came out ? harder than I thought.

翻譯年糕

Sorry, dumb question, I have shrink this print to 75%.. almost full height..how long would this take? I don’t want to add auto support, as it added 300 or so support on this stl.....

Using monocure rapid at 100 microns

翻譯年糕

POST CLEAN UP IS DONE IN MY GARAGE BY MY PRINTER. I ALWAYS WEAR GLOVES. Ok, Monocure resin. It is VERY reactive to water. What is the best way to clean if you get some on your hands? Even the tiniest bit on my hands stinks up the whole bathroom and my bedroom when I wash with soap and water. The smell sticks to the sink it seems. What the hell do I need to do? I had literally kust gotten a small dab on my arm while cleaning a print in my IPA tub.

翻譯年糕

Probando a hacer latas de conservas ? ? ? . Siento que en las fotos no se aprecie mucho el relieve, pero el zoom del movil estaba al maximo ? ? ? . En cuanto pueda le doy una capa de inprimacion con el aerografo para ver el resultado ? ? ?

翻譯年糕

This Wanhao Orange is not working. I have gotten one good print out of four attempts since it arrived.

I upped the exposure to 15 seconds per layer, and it still just failed.

I'm not sure what to do. I recalibrated the print bed in case that was the issue... and now I'm at a loss.

Can anyone recommend a really good white?

I bought the orange thinking it was a nice translucent amber, but it's not. It's an ugly ugly mostly opaque tangerine and I really dislike it.

I want to see detail. The green that came with the Photon is awesome. I want more of that. But a white and a black are also part of my plan.

Can anyone recommend the best black and the best white?

翻譯年糕