I completed an unplanned experiment overnight.
I was printing some T Rex pieces and when I went to check the progress before going to bed I realised that I'd misjudged how much resin I had left. I was pretty sure I was going to run out of resin before the print was done. I had been printing with the Wanhao grey.
My options were to cancel the print, leave it to run and hope there was just enough for it to finish or...
I had a little Anycubic green left over in the bottle - not enough for a print, but what if I was to mix it into the vat?
So that's what I did, I paused the print, topped up the vat with the green, mixed the 2 together, and left the print to finish overnight.
And it worked perfectly. You can see where the colour changes, to the touch it feels the same throughout. Once primed & painted you'd never know.
Sadly, I'm just about out of resin, maybe enough for some of the tiny pieces to get printed. Can't wait for my monocure order to arrive so I can continue with the larger pieces and get this model built.
翻譯年糕