Anycubic Photon Printer Owners 造訪社團

Hello, I recently bought this printer and noticed that the estimated print time provided by the slicer is around a 30% lower than the real printing time. Is this normal or my printer is slower than intended? Can the time be tweaked in the slicer so ti is more accurate? (It looks like the sclicer is not taking into account the retraction time for each layer, only the exposure and pause intervals).

翻譯年糕

So ive got 28mm miniature i want to print at 10mm and preserve as much detail as possible. Any advise/settings?

翻譯年糕

Hi there and sorry for that noob question.
What do you do after printing?
There is still some resin all around the model. Do you clean with water/alcohol? And harden it after cleaning with UV?

翻譯年糕

First print done
Right first time
Soooo impressed

翻譯年糕

When the printer decides to quit at 94%

翻譯年糕

Finally ... Wasted lot of resin on this model. Failed 2times.

翻譯年糕

Federation runabouts

翻譯年糕

Flint Read your leveling technique was frustrating because I kept forgetting to go up 3 afterwards but once I did it right my test came out great. No issues.

翻譯年糕

First print went well tonight. Just the test print but I was testing my ventilation setup which worked very well. What I ended up doing is venting from the top in a 4" duct. I replaced the upper window with a part from thingiverse and connected to a cheap 100 cfm fan through another 4" duct to a custom created window insert. I then flipped over the fan inside the photon to have it vent up into the build area to have proper air flow. It didn't move a lot of air with the length of the duct work but it was enough negative pressure to have no odor at all.

翻譯年糕

Has any flexible resin been tested other than the Photocentric one on the gsheet? Looking for something comparable to TPU. thanks!

翻譯年糕