Anycubic Photon Printer Owners 造訪社團

Hello, do any other slicers produce printable files for the photon - except the supplied one?
Got my printer ordered and I am exploring my software options.
Thanks

翻譯年糕

hello everyone :) ... i know it is recommended to shake the resin before printing ... however, when i shake it and fill the resin tank to start printing, the resin if full of air bubbles (caused by shaking) ... i was wondering, doesn't that affect the print quality ? :)

翻譯年糕

Work in progress for a friend who made triple elite at the new year more parts to come and a lot of painting it's hollow and 160mm long

翻譯年糕

Anyone running their printer behind a UPS? I keep getting failed prints due to power cuts to my whole street at night - happened 3 times in just over a week.

翻譯年糕

Hi all

I have the problem with the power.
I bought this printer in Thailand about a week ago and print for 3 jobs. It's quite OK.

But yesterday I start to prepare the new job so, I try to setup home level then the printer stop and lost the power. When I check with the cable cord it's still have the power (the photo). Anyone ever see like this. Please advice me.

Thank you

翻譯年糕

Now we know there is a clear acrylic panel below the screen, let's discuss how we can modify it (just because we can ? ).
Base on this chart Fused silica glass is the absolute best for uv transmission so anyone here can source good quality fused silica glass and give it a try?

What's your opinion? Let's discuss

翻譯年糕

Ok so after a succesfully print on Anycubic resin, yesterday I bought a Fun to do standard blend red resin and of course give it a try. Unfortunately failed attemp.

翻譯年糕

I'm seeking guidance regarding power intensity of the Photon UV lamp. I would like to use the Photocentric resin I purchased for the Photon in my Nobel 1.0 UV Laser printer. Since the Photocentric takes such a long exposure time to cure with the DLP, I was wondering how much power it would need to cure with the UV Laser ( adjustable power ranged from 0 -72mW). I don't want it to fry the resin, but I have no idea where to begin. Any advise is greatly appreciated!

翻譯年糕

Is there a way to add supports in the A.Photon slicer without raising all of the model off the table ??

翻譯年糕

Hmm, received my Photon today...
But trying to tighten the platform with the included allen wrenches, and neither will tighten it as instructed. Also, there was no allen wrench to tighten the knob screw included with the printer. I am almost feeling I got the wrong sized allen wrenches. Can anyone confirm? And when the platform is tightened, does it stop being able to swivel? The red knob is tight.

翻譯年糕