Anycubic Photon Printer Owners 造訪社團

While doing my first print, the power went out. I was three hours in, on a 6 hour print. I guess I'll have to start over. Unless someone can tell me how to pick up where it left off.
Thanks

翻譯年糕

Sizing issues again. Boosted from 75mm to 85 mm saved, resliced, put on a NEW usb stick. Printed same size as 75mm ones.....

翻譯年糕

Hello, why does the resin stay below?

翻譯年糕

https://www.facebook.com/baconinabun/posts/430840690671471
Anycubic Photon, Wannhoe Red resin 0.03(Settings:Daniel Ignacio Perez) FORTNIGHTs S.C.A.R ;) Sholm Jarboe https://www.thingiverse.com/thing:2840163

翻譯年糕

Is my Paranoia normal?
When i Start a Print with new Material or new Settings i press "pause" ( break) After 15-20% to see if the First Layer are stick Good at the Build Plattform
If Yes i Continue
If not Change Settings
Try again

翻譯年糕

Bottlecap of the adecuate size (13.2x30mm) for changing FEP sheet. Hollow so it uses less plastic/resin

翻譯年糕

How long do your fep sheets normally last?

翻譯年糕

What slicer do you guys use for support generation? Is the one from Anycubic any good?

翻譯年糕

When replacing FEP sheet you're supposed to use a bottle cap to get the right amount of slack so you can tighten it up. Has anyone found something to print that can be used instead of a bottle cap as they all seem to be very different sizes. Seems like the perfect little thing to print out so that the sheet tightens right first time, every time.

翻譯年糕

Has anyone used the Anycubic White? and does it use the same settings as the green?

翻譯年糕