Anycubic Photon Printer Owners 造訪社團

Second quick guestion. Have anyone used thinner than 0.15mm FEP film on Photon? Maybe 0.10mm? My local FEP supplier only has 0.10mm

翻譯年糕

More prints with FunToDo unpigmented, this industrial blend is very solid, the supports stay well in place. I did the supports in XYZ Nobel software / auto - medium - small
Soldier is 30mm, Meta human is 70mm. Curing now, then primer ;)
For the soldiers, I wanted to compare photon supports and XYZ Nobel supports, both did the job, but the ones from the photon were way easier to remove and left less defaults.

翻譯年糕

Quick question. What is the thickness of FEP film in Photon?

翻譯年糕

Mp40 - barrel and mag / Photon - Grip and rear part / Wanhao D7 ? 0.05 Monocure Rapid White and Photon Stock Emerald Resin.

翻譯年糕

I'm trying to prepare this model for printing. How would you guys set it up?

I've angled it 45 degrees and hollowed it to 1.5mm walls with Meshmixer, and added auto supports with B9Creator.

However, the interior is riddled with supports, and I'm not sure if I'm on the right track with this. Any help would be appreciated!

https://www.thingiverse.com/thing:982708

翻譯年糕

NEED ASSISTANCE. My fep sheet cracked halfway through a print. I need the top glass of the screen. The screen. And the thick glass under it. Go directly to anycubic for parts? And the resin leaked in and cured between all the layers. None got inside the printer. The light is ok. It didn’t make it down that far.

翻譯年糕

This is going to be an expensive hobby.... ;-)

翻譯年糕

To anyone who is using Formware for supports...

I'm evaluating this software and loving the support functionality except for one thing. Some models show the "critical" overhang areas incorrectly.

I've attached an example below. Notice hot the model is oriented vertically, but the overhang (red, yellow) area shows along the vertical surface along the back. It should show at the bottom of the tail (red arrow I added). This wouldn't be a big deal, except it prevents me from adding support exactly where I need to.

I'm fine using B9 for supports, but Formware has features B9 doesn't. I won't buy it if I can't figure this out.

翻譯年糕

Hi Guys, just wanted to let you know that I have set you up a coupon code for Monocure 3D resins. Please use MONOPHOTON to get 10% off your order. Also, we have just introduced a new colour that I thought might interest some of you... I will be officially launching it in April, but you can buy it now from our web shop. Please feel free to contact me directly if you ever need any help with our resin. Thanks, Charlie

翻譯年糕

Has anyone customized the printer configuration in B9Creator? I'm trying to make a profile for the Photon's build volume, but can't seem to find the right properties in the config file.

翻譯年糕