Hi, after a long time i finally found the common point in my prints problem (i`ve been looking for what problem it is)
The common point in my prints that make lines being more larger or thinner than it is supposed to be is the lines that have, in any point, top/botton lines or straight angles (0 or 90 from the table).
The lines are not shifted, they are all fatter or thinner.
I`ve made my tries with low speed in print and travel, high speed, temperatures, put all printing at same speed, changing retractions, zhops, increasing the number of walls.
Thighened the belts, relased the belts...
Can someone help-me find the name of the problem to search how to solve, or if someone know how to solve this?
The printer is a Atom 2.5ex.
Those photos are from my last try... the strings was due to low retraction i was trying... its not a usual problem)
翻譯年糕
Joe Abaquin Bing Aquino
2019-04-27 07:36:29
I get that too when using the sketchup.
I have asked this to other makers and they mention to add TL-smoother kits.
They explain that because currents run through wires and it jumps a bit like a noise.
……
查看更多
Birk Binnard
2019-04-27 09:14:44
邢鳳言
2019-04-27 09:56:27
Do you have the constant hotend temperature? mine was floating 185~202 degree C, then I had it wrapped to solve the problem, it was cooled by the side fans, and heated by the heating ceramic all the time since the 2nd layer in my case.
Alan Santos Dias
2019-04-30 06:42:30
I`ve changed the slicer... same settings as before (i`ve put the same value in all the options), and it worked fine.
