• 3D列印服務
  • #maker+t=market
  • COSPLAY 3D 建模
  • 1
  • 2
  • 3

ATOM 3D Printer Group 造訪社團 » 用戶發文

原文網址 Todd Whetstone
2019-03-23 14:48:19

When trying to auto level my Neutron, this is what I get. The effector wont go all the down to the build plate, it stays some where around 140-150mm above the plate, goes through all the motion of leveling, but does nothing. I increased my build height from 200mm to 220mm, but I'm not sure where to change it in the firmware. Any help would be very much appreciated. I'm excited to get printing.

翻譯年糕

James Lin
2019-03-23 14:58:59

這台好像沒這麼高~

Yohann Toutain
2019-03-23 18:27:10

First use the height by default (225 if i remember), then in your Marlin firmware, you should have this line: # define DEFAULT_AXIS_STEPS_PER_UNIT, increase the values on X, Y and Z until you can do the auto leveling properly. Then make some XYZ cubes test to verify if it respect the good tolerances and adjust if necessary. If you have problems of under or over extrusion you will have to do the same for the E.

Malak Ghorghi
2019-03-23 19:30:26

Hugo Lopez Uria here a nice conversation I saw maybe to be useful for you.

邢鳳言
2019-03-25 04:33:43

# define DELTA_HEIGHT 230 // get this value from auto calibrate
in my case, to make sure the bed would be probable.


原文網址 Todd Whetstone
2019-03-23 12:50:51

Finishing up on my Neutron and I was wondering if anyone is using Simplify3d? What profile do I use and if someone has a profile to share with me? Any help would be much appreciated.

翻譯年糕

Yohann Toutain
2019-03-23 18:31:15

You use carbon rods on your machine?


原文網址 Todd Whetstone
2019-03-12 07:58:45

Hey group, I hate doing this and being the 'annoying ask a million questions' guy, but I just noticed that i have t8x2 lead screw instead of the standard t8. What is the difference in the screw as far as pitch and revolution goes? I want to make sure I get accurate prints when this thing is complete.

翻譯年糕


原文網址 Todd Whetstone
2019-02-14 15:20:36

Hey all, I'm currently in the process of building my Neutron printer and I was wondering if someone could link me to a proper writing diagram for the MEGA2560+Ramps 1.4. I want to make sure I have all my axis' and end stops in the proper place when wiring. Thank you for any help I can get.

大家好, 我目前正在建造中子印表機, 我想知道是否有人可以把我連結到mega2560+ramps 1.4. 的合適的寫作圖, 我想確保我所有的axi have all my axi 電線時合適的地方. 謝謝你的幫助我可以得到.

· 查看原文 · 為此翻譯評分


 

全不選 常用關鍵字