Hi guys!
Im using my Photon pretty freqent, its been printing non-stop for a week, and it behaves really well, on the other hand, the resin, not so much!
When ive let it print over night and come back to in the morning to start a new print, the resin sometimes is not good to go, it need to get blended/stired, otherwise the detail got lose of the supports.
When it happens, i just stir the resin and its all good to go again, same file prints flawlesly once its done.
If i look at the startup gcode in the new Chitubox, it lets me write whatever i want.
Im thinking of adding the follow lines just to stir the resin a little before it starts a new print.
G21;
G90;
M106 S0;
G28 Z0;
G1 Z15;
G1 Z0.3;
G1 Z15;
G1 Z0.3;
G1 Z15;
G1 Z0.3;
G1 Z15;
G28 Z0;
What do you think? Does it understand native g-codes?
Im thinking if it works with G0 commands.
翻譯年糕
Zena Andreou
2019-03-08 02:38:36
Paul Mabbott
2019-03-08 02:40:16
Kevin McGuigan
2019-03-08 03:31:44
Kostas Filosofou
2019-03-08 04:46:11
David McGyver
2019-03-08 08:50:14
David McGyver
2019-03-08 11:35:53
