I split this model at the torso and the arms for easier printing and made a peg to connect to the torso but none of the pegs fit in the sockets. I assume this is due to shrinking/warping.
In the end i just snipped the pegs off and glued the parts together, but I was wondering if anyone had any advice on how to make some reliable connections in a multipart model.
Resin is Anycubic Grey
翻譯年糕
Tanner Levi
2019-02-06 04:31:31
Seona van der Pol
2019-02-06 04:54:19
Mark Wardle
2019-02-06 04:57:05
Stephen Francik
2019-02-06 04:58:14
Jordan Geml
2019-02-06 05:11:27
Stephen Francik
2019-02-06 05:14:14
Jordan Geml
2019-02-06 05:15:15
Jordan Geml
2019-02-06 05:18:45
Mark Wardle
2019-02-06 05:19:30
Stephen Francik
2019-02-06 05:20:41
Jordan Geml
2019-02-06 05:22:09
Mark Wardle
2019-02-06 05:22:48
Stephen Francik
2019-02-06 05:25:27
Jordan Geml
2019-02-06 05:39:49
Stephen Francik
2019-02-06 05:41:44
Jordan Geml
2019-02-06 05:42:24
Ed Gaulton
2019-02-06 07:15:21
Orwin SantaCruz
2019-02-06 07:19:25
Richard Shapiro
2019-02-06 07:47:48
Stephen Francik
2019-02-06 07:49:21
Richard Shapiro
2019-02-06 07:53:19
Stephen Francik
2019-02-06 07:54:17
Richard Shapiro
2019-02-06 07:54:18