Hey Gang Im a bit new to 3d printing and I have been having some issues with my prints. So the two main issues is the low detail in some areas and the holes in the print. I made sure the resin had no bubbles in it before the print and I didnt see any when it finished so any feedback and advice you guys could give me on the print would be greatly appeeciated thanks
:D
.
翻譯年糕
Ekaterina Vitalyevna
2018-12-04 21:15:39
Robert Fliege
2018-12-04 21:16:04
David Clements
2018-12-04 21:17:40
David Clements
2018-12-04 21:18:50
Ivo Mavrodinov
2018-12-04 21:21:15
Çağrı Aydoğan
2018-12-04 21:22:11
David Clements
2018-12-04 21:23:45
Daniel Kearns
2018-12-04 21:26:37
David Clements
2018-12-04 21:31:21
Kyle Turgoose
2018-12-04 21:32:13
David Clements
2018-12-04 21:36:02
Chad Elstad
2018-12-04 21:46:39
Stefan Giudici
2018-12-04 22:35:09
Bronson Ferri
2018-12-04 22:45:39
Adrian Walle
2018-12-05 00:06:17
Daniel Tickell
2018-12-05 00:43:54
David Clements
2018-12-05 01:02:30
David Paquette
2018-12-05 01:18:25
Seb Jägermetal
2018-12-05 03:05:15
Fred Breton
2018-12-05 03:11:28
Sen Kun
2018-12-05 03:21:39
David Clements
2018-12-06 05:18:57
David Clements
2018-12-06 05:19:55
Daniel Tickell
2018-12-06 05:20:09
