ok... about to lose it with this photon. brand spanking new, levelled, zero'd and failed to print a damn thing apart from either print a solid block on the fep, and or the head, with no actual print done at all... every time... any suggestions please.. I have wasted an entire bottle of resin on this so far, and I'm reaching the end of my tether... it simply doesn't work. the exposure seems to light correctly by layer after doing a dry test, so wtf is going wrong???
翻譯年糕
Sen Kun
2018-12-14 04:42:03
Mikko Asikainen
2018-12-14 04:42:32
Lee Mahon
2018-12-14 04:42:49
Sen Kun
2018-12-14 04:43:33
Sen Kun
2018-12-14 04:46:57
Bob Ferraris
2018-12-14 04:57:42
Nick Leijenhorst
2018-12-14 05:17:57
Stefan Giudici
2018-12-14 08:06:34
Sam Cunningham
2018-12-14 08:10:37
Nemo Vilpponen
2018-12-14 09:34:05
Nemo Vilpponen
2018-12-14 09:35:30
Nemo Vilpponen
2018-12-14 09:36:22
Sam Cunningham
2018-12-14 09:38:20
Nemo Vilpponen
2018-12-14 09:45:28
Marnie Jefferson
2018-12-14 18:32:52
Jay Stein
2018-12-14 18:40:45
Lee Mahon
2018-12-14 19:10:32
Lee Mahon
2018-12-14 19:30:56
Mikko Asikainen
2018-12-14 20:03:49
Lee Mahon
2018-12-14 20:25:11
Lee Mahon
2018-12-14 20:25:58
Lee Mahon
2018-12-14 20:26:28
Mikko Asikainen
2018-12-14 20:43:12
Lee Mahon
2018-12-14 20:45:10
Mikko Asikainen
2018-12-14 20:46:34
Lee Mahon
2018-12-14 21:23:07
Jay Stein
2018-12-15 03:11:35
Lee Mahon
2018-12-15 03:16:55
