Anycubic Photon Printer Owners 造訪社團 » 用戶發文

have been experimenting with my photon and looking at the issues in prints that look like lines are in them - which is often attributed to z-wobble and model alignment.

I had been using .05mm layer thickness for some prints and was getting lines.

Then I read that the stepping of the device is in .02mm

I tried .02mm and .06mm and no lines.

currently using the following settings with the white resin and i am getting great prints every time now.

White - Anycubic POT015 LCD Uv 405 nm Rapid Resin for 3D PRINTER-500Mll/ 500G-White
layer 0.02
Normal Exposure 12
Off time 6.5
Bottom exposure 115
bottom layers 8
heavy supports with contact depth at 0.35
30% support density

翻譯年糕

the spare FEP sheet that ships with the photon - is there some sort of protective film on it? it felt thicker but damn me if i could seperate a protective cover from it and could not see any instructions to remove one.

installed the new sheet and first print a blister appears (hence the question).

翻譯年糕

repurposed paasche airbrush booth.

翻譯年糕

first sucessful print - footbridge that i airbrushed in 10 minutes.

翻譯年糕

After a lot of trial and error, here are the settings that are working for me with my photon.

Layer 0.05
Normal Exposure 12
Off time 6.5
Bottom exposure 115
bottom layers 8

heavy supports with contact depth at 0.35

I am using the White rapid resin.

Thanks for the various hints and tips here - they've really helped getting me dialed in.

翻譯年糕