Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Occasionally on startup my Photon's fan makes a loud, grindy noise. If I restart the machine the noise stops and the normal fan sound returns.

The first time this happened the noise eventually tapered off, but when I tried printing, after lowering to home the printer sounded like it was attempting to ram the build plate into the lcd screen. I had to quickly shut it off. It seemed to work fine after restarting.

Any idea what the problem is? It happens every ~6 or so start ups. I have about a week to replace it with Amazon if it's serious.

翻譯年糕

$12 fume box. The box is what amazon shipped it in, duct tubing from hardware store, and a sheet of anything to seal with a window. Meat thermometer optional just to monitor the temperature

翻譯年糕

Is there anything I can dip or spray models with to strengthen them whilst preserving detail? I want to counter their brittleness from small drops and the like.

翻譯年糕

Do any solvents work on cured resin? I'd like to smooth out support marks.

翻譯年糕

Could you guys help me with a few questions regarding the film please?

1. What causes permanent marks to develop on the FEP film?

After replacing the film, the first print on it succeeded, but had very loud peeling sounds, left permanent marks, and had a large layer of cured resin stuck to the bottom on two attempts. My film now has cloudy marks in the shape of the prints, and divots in the film itself.

2. How do I avoid marring the film when replacing it?

When replacing the film I used a bottlecap as in the video, but it left a small imperfection in the film that did not go away when tensioned.

3. What are the symptoms of a film that's too tight or too lose?

My factory film install seemed perfect, I didn't even tighten it when I got it. Now, as mentioned before, the peeling sounds are loud and it's marring easily. Does this mean my film is too tight or too loose?

翻譯年糕

How tight should the FEP film be? I just replaced mine and it's nice and drum tight, however now my prints are noticeably louder when unsticking from the film, and the bottom of the film is suctioning more to the LCD screen below. I didn't tighten the vat screws all the way because it seemed tight enough. Should it be tighter? Looser?

翻譯年糕