Looking for some guidance. I’ve had this printer about a week and for the most part I’ve had success. I created these fruit crates for model railroading. Biggest is O scale (1:48) down to Z scale (1:220). I thought it would be a slam dunk print but most of the crates are filled. Since the pattern is consistent between items and sizes I was convinced I had a random plane I thought to delete in Sketchup. But looking at the model is looked fine. Same with the slicer. Thoughts? Could a reversed face cause this? I did my best to make sure all faces were correct but maybe I missed one.
Layer height: 0.25
Layer time: 10s
Off time: 2sec
Base layers: 10
Base layer time: 60s
翻譯年糕
Chris Crute
2019-01-30 21:16:51
Brandon Piening
2019-01-30 21:23:45
Michael Peters Bond
2019-01-30 21:27:15
Sen Kun
2019-01-30 21:34:41
Brandon Piening
2019-01-30 21:34:55
Gareth Jones
2019-01-30 21:37:54
Sen Kun
2019-01-30 21:38:06
Tim Watson
2019-01-30 21:39:57
Philippe Maegerman
2019-01-31 00:08:06
Michael Peters Bond
2019-01-31 01:35:28
Michael Peters Bond
2019-01-31 01:36:14
Richard Wilson
2019-01-31 04:03:15
Tim Watson
2019-01-31 21:57:06
