Hi, last week, I smell resin in my workshop but I didn't use the photon since two months. tonight I opened a box where I store my printed parts and found a part with cracks and liquid resin in the bottom of the box! This was a part printed months ago, hollowed but with no drain hole, my bad. But I saw another part with cracks and this one had a drain hole and had been bathed in IPA. The resin each time is a mix of anycubic (green or blue) with monocure flex 100 (ratio 75/25 approximately)
Did you already experienced that ?
翻譯年糕
Rob Mayberry
2019-06-06 04:09:50
Thomassen Ølf
2019-06-06 04:11:40
Shreyo Bagchee
2019-06-06 04:22:19
Paul Churchill
2019-06-06 04:23:59
Vincent Faure
2019-06-06 04:25:50
Vincent Faure
2019-06-06 04:28:37
Vincent Faure
2019-06-06 04:30:31
Bradley VanScoyk
2019-06-06 04:58:16
Scott Miller
2019-06-06 05:01:10
Vincent Faure
2019-06-06 05:29:09
Stefan Giudici
2019-06-06 05:33:48
Stefan Giudici
2019-06-06 05:35:21
Sean Pollman
2019-06-06 08:02:20
Dan Smith
2019-06-06 11:48:10
Tim Moulton
2019-06-06 13:19:32
Dan Smith
2019-06-06 14:22:39
Christopher Ashworth
2019-06-07 02:08:38
Justin Elliott
2019-06-07 08:07:31
Tamino Wirz
2019-06-08 20:37:46
