• 3D列印服務
  • COSPLAY 3D 建模
  • #maker+t=market
  • 1
  • 2
  • 3

Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Stephen Arsenault
2019-02-25 03:27:37

I've seen the recommendation to tape around the screen in order to prevent an unfortunate vat leak from dripping into the machine.

Is there a specific tape recommended or will any clear tape do the trick? Would it be conceivable to tape the entire screen to prevent scratches / resin build up?

翻譯年糕

Jon-paul Blinston
2019-02-25 03:29:04

Richard Rose
2019-02-25 05:11:02

Susan Sioux Mercer
2019-02-28 01:33:08


原文網址 Stephen Arsenault
2019-02-19 11:18:24

I was getting ready to celebrate my "first" decent print, but when I took it off the print platform I found it had layer marks — possibly Z-wobble?

I scored lines across my print platform at 2mm intervals, sanded the print surface flush, re-leveled the platform.

Any suggestions? This is beginning to get annoying!

翻譯年糕

John Boyington
2019-02-19 11:32:29

Kyle Curtis
2019-02-19 12:08:26

Bahattin ManusH
2019-02-19 13:53:26

Stephen Arsenault
2019-02-19 13:55:35

Bahattin ManusH
2019-02-19 14:07:40

Stephen Arsenault
2019-02-19 14:11:22

Zena Andreou
2019-02-19 14:59:12

Peter Ede
2019-02-19 17:55:43

Savio Ku
2019-02-19 21:40:05

Peter Ede
2019-02-20 05:14:08

Savio Ku
2019-02-20 05:14:56

Stephen Arsenault
2019-02-20 10:45:45


原文網址 Stephen Arsenault
2019-02-17 08:21:31

I'm trying to print a small replacement switch... but after about 8 tries I haven't had any success.

The supports keep disconnecting from the outter body of the switch and it comes out looking pretty bad.

Any ideas or recommendations would be greatly appreciated! This is with the Monoprice Rapid UV Clear

翻譯年糕

Che Fielding
2019-02-17 08:30:54

Robert Anhalt
2019-02-17 08:47:13

Jim Leenan
2019-02-17 09:01:25

Stephen Arsenault
2019-02-17 09:02:28

Sean O'Hayer
2019-02-17 11:43:59

Stephen Arsenault
2019-02-17 11:51:38


 

討論主題

全不選 常用關鍵字