Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Can anyone recommend some high temp resin to make soldering jigs for circuit boards? I want to hold a circuit board and components in place whilst they are soldered.

翻譯年糕

Having so much fun with this printer already. Will likely scale up the full skull to be similar sized, but for now, it’s enough to do some terrain and basing!

翻譯年糕

I'm relatively new to all this. I've managed to work my way through the green resin that came with the printer. It was super-smashing-great, and then heard that the grey was pretty good.
I've done a couple of the prints with the grey. The first thing I noticed was it's WAY more sensitive to UV. I took it out for less than a few minutes and it developed a "skin" that had to be filtered off! The green did nothing like that!

Whats your favourite resin? I'm mostly doing 28mm miniatures and terrain

翻譯年糕

i keep hearing a clicking type sound on every layer change. Almost sounds like the bed is sticking to the screen then lifting up. Any ideas what could be causing it? should I re-cal the head?

翻譯年糕