Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Andrew Delisle
2019-03-12 21:11:23

I know this might not be the right place to ask, but I can't figure out how to manually add supports in ChiTu Box slicer. Whenever I try, it's not connected to anything and sometimes off the build plate entirely... What are the steps for this? It doesn't seem as intuitive as the Anycubic Slicer

翻譯年糕

Mike Roof
2019-03-12 21:30:58

陳彦廷
2019-03-12 22:12:14

原文網址 Andrew Delisle
2019-02-26 04:32:08

Yes, most of them were printed on my Tevo Tornado... but I did print one on my Photon. Check it out!

翻譯年糕

原文網址 Andrew Delisle
2019-02-25 01:02:22

Check out my initial thoughts on this sweet printer!

翻譯年糕

原文網址 Andrew Delisle
2019-02-21 04:44:08

Just got my Photon yesterday. Love it. It took me a three tries to get the bed gap set correctly. I am used to measuring on FDM printers, where you want a slight drag on the paper. The photon needed a good amount of friction. After that it’s been flawless.

So, my question is, what does everyone print? I have the Eiffel Tower queued up and some lattice designs. Just want to print some small high detail things that don’t require supports.

Thanks in advance!

翻譯年糕

Jean-François Meloche
2019-02-21 04:47:32