Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 James Joubert
2019-03-26 02:08:53

So I'm getting great prints...
But after every print I need to re-level else I only get failed prints after the first good print.
Anyone encountered this issue before.

The nut is screwed in tightly, I can't even adjust the bed if I tried, as per the official video.
FEP is good, replaced recently, as per the official video.
Tightened Z axis to prevent wobble, as per the official video.

Bed is flat, placed against tiles, table or glass it almost has a suction effect.

翻譯年糕

Harry Colquhoun
2019-03-26 02:10:30

James Joubert
2019-03-26 02:11:50

Susan Sioux Mercer
2019-03-26 02:16:33

James Joubert
2019-03-26 02:19:39

Susan Sioux Mercer
2019-03-26 02:26:32

James Joubert
2019-03-26 02:27:11

Susan Sioux Mercer
2019-03-26 02:27:54

原文網址 James Joubert
2019-03-22 16:36:45

I'm getting a bit of a warp on my prints.
Flat surfaces have a slight curve to them, like the bottom of mini or where I cut models in two.
So they don't glue together perfectly without sanding.

Any tips or ideas?

翻譯年糕

Darron Rodrigues
2019-03-22 16:44:10

原文網址 James Joubert
2019-03-18 02:44:40

What support settings do you all use for miniatures?
I'm getting hit and misses with the following settings:

-TOP-
Radius: 0.6
Length: 2
Contact Depth: 0.25
Angle: 45

Should I up the contact depth?

EDIT:
Support structures print fine, but some miniatures doesn't adhere well for some odd reason.

This mini specifically struggles:

翻譯年糕

原文網址 James Joubert
2019-03-17 21:38:11

How tight should the FEP be?

Since I replaced it I can't get any successful prints.

I followed the instructions perfectly, even put the bottle cap under the FEP before screwing it in place.

EDIT:
- FEP is tight like a drum
- Bottle cap was the correct size
- Protective layers are removed from the FEP

Issue seems to be one of the following:
- Bad STL file
- Slicing issue (Will re-slice and try again)
- Apparently the Photon USB is bad quality and can affect print quality (Will try another USB)

翻譯年糕

Sen Kun
2019-03-17 21:39:45

Ian Moriearty
2019-03-17 21:39:50