I’m pretty new to this, so likely operator error.... I was not trying to print a kryptonite block!! The whole vat was empty when I went to check my print and everything cured.... the settings for the resin were correct in the software. Can anyone help me with what I did wrong? Thanks!!!
翻譯年糕
Richard Thomas
2019-03-19 22:21:31
Che Fielding
2019-03-19 22:21:52
Marko Tadros
2019-03-19 22:23:48
Adam Fitzgerald
2019-03-19 22:24:00
Derek Reihe
2019-03-19 22:26:53
Philippe Maegerman
2019-03-19 22:27:46
Simon Alzola Herrera
2019-03-19 22:28:18
Mike Roof
2019-03-19 22:29:56
André Nettermann
2019-03-19 22:32:26
Toni Jurjević
2019-03-19 22:33:45
Mike Roof
2019-03-19 22:35:17
Dave Smith
2019-03-19 22:36:40
Wendy A. Clark
2019-03-19 22:36:44
Simon Alzola Herrera
2019-03-19 22:38:22
Dave Smith
2019-03-19 22:40:02
Mike Roof
2019-03-19 22:41:01
Wendy A. Clark
2019-03-19 22:42:15
Mike Roof
2019-03-19 22:42:54
Richard Thomas
2019-03-19 22:44:35
Mike Roof
2019-03-19 22:44:45
Oni Cron
2019-03-20 00:52:18
Sen Kun
2019-03-20 01:31:49
Çağrı Aydoğan
2019-03-20 02:26:23
Simon Alzola Herrera
2019-03-20 03:19:40
Susan Sioux Mercer
2019-03-20 04:07:07
Bob Martin
2019-03-20 10:09:16
Susan Sioux Mercer
2019-03-20 10:10:53
Mike Krikunov
2019-03-20 13:45:37
Brayden Funk
2019-03-20 18:02:32
Mark Wardle
2019-03-21 04:56:25
Mark Wardle
2019-03-21 04:58:42
