Hi,
I just broke a model, and there are uncured resin inside of it.
Is there any way to avoid this ?
I have hollowed the model and cured it, but there are still slimy resin inside
?
翻譯年糕
Sander van Deijl
2020-03-24 17:20:05
Put holes in the model and rinse it out during the washing phase. Hollowed models should always have holes in the
David Cornell
2020-03-24 17:20:13
Did you put a hole in it?
Simon Nordahl Thomsen
2020-03-24 17:21:10
Yes i put holes in it if i remember coreect
Jon-paul Blinston
2020-03-24 17:24:45
Someone was making/selling led light wands to cure internal resins. You basically inserted the 3mm UV led into a drainage hole and turn it on?
Sam Applegarth
2020-03-24 17:24:56
Always add TWO holes to a hollowed model. One lets air out while the other lets water/IPA/cleaning liquid of choice in. Dunk the model, roll it around under the cleaner liquid so that it gets into all the pockets inside, and keep it under until you sto
p seeing air bubbles come out. Remove from the liquid, cover the holes with your finger(s) and give it a good shake to help dislodge any stuck particles inside. Let the liquid drain out of the holes. Repeat 2-3 times.
John Chrapkowski
2020-03-24 17:58:28
Use a syringe to squirt into the hole
Felix Olbrich
2020-03-24 18:09:01
Could you Show us a Pictures of the Print? I would Like to See how big the Print is.
Jim Nelson
2020-03-24 21:42:27
I always add at least 2 of the largest holes that will fit on the model. Once off the plate and out of the ultrasonic cleaner, clean out the interior supports as much as possible using a pair of long tweezers. Then I use a 100 cc syringe to flush the i
nterior, taking care to try and get into any interior corner. When curing in sunlight, I always take care to expose the side with holes to sun for a good while. If that seems insufficient, or if its rainy or cloudy, I use these small UVs to illuminate the interior.
TJ Robichaux
2020-03-24 23:06:47
When you hollow you also need to ensure there are no "chambers" that hollow without access to your drain holes
Simon Nordahl Thomsen
2020-03-25 00:32:06
Thanks for your replys... will do diffrent in the future
(Y)
Bill Griffin
2020-03-25 02:12:47
and where would one get those?
Jim Nelson
2020-03-25 02:19:19
Bill Griffin
2020-03-25 02:29:42
What is the name I should search for what brand
Bill Griffin
2020-03-25 02:32:11
Jim Nelson
2020-03-25 02:32:16
Bill Griffin
2020-03-25 02:32:53
:P
Just posted same one on .ca
Bill Griffin
2020-03-25 02:33:43
Bill Griffin
2020-03-25 02:34:44
No one selling as of right now on either Amazon
:(
Stefan Giudici
2020-03-25 15:19:34
Put holes near the build plate so air can get in while printing
Nikola Pijanac
2020-03-25 16:08:05
If you put holes in your model, eg at the bottom of the feet of a model or any other place where you wont notice the hole so much, allows for your cleaning fluid to go into the model so you can swish it about and allows for any uncured resin to drain out. If you dont want to add holes then leave your model to cure in sunlight and that will generally get to any residue resin inside the model.
