Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi Everyone,

So far I've had pretty good success with printing figures (~30-45°). I have the resin settings chart and have tried printing at 0.05 and 0.02 layer thickness, again with fairly good success.

The issue I am having now is trying to print flat parts (non-figures). I am trying to print directly on the plate since they are relatively simple parts. Do I still have to raise them up and add supports or is there any suggested settings for it? The picture below is an example of something I am trying to print. It is either a globby mess or it doesn't stick depending on whether I increase or decrease the bottom layer settings.

翻譯年糕

Hi all! Finally got a chance to get my photon up and running. I plan on priming and painting most of my models, but for the ones I am not, is there a clear UV resistant spray available? I have clear lacquer but it doesn't appear to be labeled as UV resistant.

翻譯年糕

Hi everyone! I just ordered mine, should get it later this week. Quick question, besides what comes with the printer are there any other supplies I should get. I know I need alcohol for rinsing. I'm planning on getting some UV lights. I've got experience with lots of commercial FDM printers but this will be my first go at this type of printing.

翻譯年糕