Making progress but would like some advice on the last bit. I'm printing a basic railway wagon on a Photon S with Elegoo Grey. The wagon is about 30mm x 15mm x 8m tall and the sides are around 0.75mm thick. Picture 1 was done with the original Anycubic green parameters - oops. The second was with better parameters - 0.02, 12, 3, 80, 5 and 30 degrees. It still had a collapsed point and I realised I was using light supports. I changed to medium supports with the same parameters and it is much better but there are still faint lines across the wagon which do appear to align with the support attachment points. Would people change the supports further in some way or increase the exposure time further to prevent what seems to be a level of compression? I should add I used 24 supports spread evenly which is significantly fewer than the auto support from the Photon Workshop Slicer.
翻譯年糕
Troy Tepes
2019-07-07 13:50:22
Stuart Taylor
2019-07-07 13:58:45
Stuart Taylor
2019-07-07 14:01:09
Stuart Taylor
2019-07-07 14:18:35
Stuart Taylor
2019-07-07 14:24:19
Stuart Taylor
2019-07-08 13:34:33
Alex Roughsedge
2019-07-08 15:10:20
Stuart Taylor
2019-07-08 15:14:50
Stuart Taylor
2019-07-08 15:16:05
Alex Roughsedge
2019-07-08 15:21:31
Stuart Taylor
2019-07-08 15:45:57
