Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Is it permissible to post a for-sale notice? I’m moving and would like to re-home my printer and a few liters of resin.

翻譯年糕

So what is the community’s opinion of Elegoo grey resin? Good, bad, wonderful, unprintable? I need more resin, my Anycubic grey is running out and Elegoo is about 30% cheaper on Amazon (how is that even possible?). Thanks in advance for the input!

翻譯年糕

Hey all, need some advice from the group mind. Anyone know why I’m getting warping and a big layer shift at the bottom of this print? I’m running it flat on the build plate to get a perfect mating surface, so I’m hoping to fix it as is. I’ll add supports if I need to, but it’s definitely a less attractive fix. Also, anyone else have issues with their build plate spinning? It stays balanced, but seems to spin easily from side to side a little.

I’m printing with:
Anycubic Grey
.02 layer height
12 sec layer
50 sec bottom layer, 3 layers

Any help is really appreciated!

翻譯年糕

Hi Phontonsters, and Happy Memorial Day (for those of you in the US). I just pulled a print off my Photon and saw some terrible results that have never happened before. Am I getting the dreaded Z Wobble? It’s always printed fine before, but now I’m getting these weird layer shifts/wavyness in the print. The bed was loaded pretty full, could that have been part of the issue? I checked the printer, everything was tightened down correctly when I started and the Z axis and lead screw aren’t loose. Any ideas how to diagnose/fix this issue? the parts in the picture are sci-fi control panels and should be all strait lines. Parts printed with supports parallel to the build plate, or attached directly to the build plate on the small end.

Elegoo green
9 sec exposure

翻譯年糕

So a little update on yesterday’s post about warping: It seems that warping isn’t actually the issue. It’s more like accumulated resin on the top surfaces (closest to the build plate) of the model. The surface in the first pic is supposed to be flat and sharp, but instead it’s lumpy and gross. Anyone have this issue with flat surfaces close to the build plate? What do I do to correct it? And how is it even happening to start with, because the rest of the model is fine...

翻譯年糕

Do you guys often have issues with parts warping? I printed up some small parts (around the size of a large 6 sided die) and the flat mating surfaces were rounded. It was on the support side, in case that matters.

eSun red bioresin
11 sec exposure
.04 layer

翻譯年糕

Hey there photonsters, what’s happening? So I need to change my FEP and I’ve seen people posting about using some kind of phone app to tune the film. What app do you all use? And what happens if it’s a little too tight?

翻譯年糕

So I just saw eSun makes resin and I’d love to know if anyone had experience with it. How does it print? Does it take good details (can I do miniatures)? Most importantly, how is the odor??? I just started using Anycubic grey and almost gassed myself out of my apartment. Any input is welcome!

翻譯年糕

Hi, I’m trying to print miniatures using Anycubic grey mixed with 20% Monocure Flex. I know a few people have tried this before, does anyone have any setting to suggest? Any kind of starting place would be really helpful, thanks!

翻譯年糕

Hey photonsters, noob question for you: how do you know when something is over or under exposed? What tells you? How do I dial a particular resin in? Any help is appreciated, thanks!

翻譯年糕