Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I'm going to buy one of the new large format resin printers to work in conjuction with my Photon-S.

What does everyone reckon is the best? My budget is around $2000.

I'm looking at the Phrozen XL, Epax X10, Phenom and Transform. Any experiences with these? Any I'm missing out?

It's hard to decide.

翻譯年糕

Tearing my hair out a bit.

The screen went on my Photon-s, so I replace it and since then, prints are pulling off their supports. Bed adhesion isn't a problem, but I think the prints are sticking to the FEP much more and pulling off the prints midway through.

Anyone come up against this? I've tried re-leveling, increasing exposure and I've just changed the FEP to see if that'll help.

I really don't want to have to re-support all my models with chunkier supports as I've got over 100 of them already presupported.

翻譯年糕

What’s the quickest way to contact Anycubic support? I sent an email a week ago but haven’t heard anything...

翻譯年糕

Successful first day with the Photon S.

My first ever 3D printer. I watched and read a lot of videos before I got it.

Test print went perfectly.

Second print was a goblin, rotated 45degrees back and 5mm off the plate. Default auto medium supports on ChiTuBox. Printed brilliantly.

Third was another goblin, printed straight onto the base plate with auto medium supports on ChiTuBox. Again zero problems.

Settings are 0.05mm, 8secs. 8 base layers at 50seconds.

Printing something a bit bigger now. I’m sure problems will rear their head soon but it’s going well so far.

翻譯年糕