Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Hi,
Been lurking and trying to figure this out myself but I'm getting frustrated so figured id ask hive mind before I end up losing my ? Chitubox (tried photon slicer, same results)
.03 layer @ 8 sec exp, 6 bottom @ 50 sec
33° angle (as per that image that always gets posted here).
Tried it in all sorts of angles and exposures and i always get these lines that look horrid and are quite obvious.

Any help would be appreciated greatly
Is there a chance that my crappy laptop is stuffing up the slicing process? Can't post a pic of chitubox atm but can when I'm home later if needed
Edit: monocure rapid clear resin

翻譯年糕

Did resin exposure test in clear monocure... this probably sounds like stupid question but anyone who uses clear have advice on how to take a good picture so I can post it here, it's almost impossible to see in person and i just cant get a reasonable picture for feedback

翻譯年糕

I am doing the resin exposure test and it's not coming out clearly (my card seems thinner than the other pics i have seen) and is hard to read, is this normal with transparent colour resins or something wrong in my setup process?

Havent had any prints fail miserably, few issues but now im trying to dial in my settings to get perfect prints

翻譯年糕

About to order some order some resin because I ran out of the starter amount in just over 2 days.
Going with Monocure because the bulk discount and the group code make it too cheap to pass up (and its only $15 postage).
Complete newbie so after some advice from some older hats.
I will primarily be priming and painting my printed stuff, so i am wondering if i should get a particular colour, clear or if it doesnt matter at all?

翻譯年糕

Probably a stupid question aboit chitubox but Google wont tell me and stuffed if i can work it out ?‍♂️
I have really small model on there and i can't see it to work on, how can I zoom in on the plate instead of scaling the model?

翻譯年糕