Did my first prinst today (the test file from Photon) but had to stop very early due to the fumes/smell whatever you'd like to call it. (Anycubic Green Resin)
Maybe I'm just sensetive to resin but my throat hurts a bit now. I've been looking around a bit for ways to well make your air clean and I found this
https://www.thingiverse.com/thing:2877754
which seems to be very good for a lot of folks.
Because of my lack of English and not using the imperial system I'm having a hard time finding the components I would require to run a setup using this rear vent adapter.
Or perhaps if someone else got any solutions that they could offer? Feels like a let-down not being able to print because of the smell/fumes
Thanks before hand (I've got a Ender 3 as well so I can print stuff out myself)
翻譯年糕
Jarrod Smith
2019-09-04 03:18:47
John Cabrer
2019-09-04 03:25:54
Victor Hjert
2019-09-04 03:31:29
Victor Hjert
2019-09-04 03:34:06
John Cabrer
2019-09-04 03:38:18
Justin Cupitt
2019-09-04 04:08:00
Justin Cupitt
2019-09-04 04:09:56
Ric Watts
2019-09-04 06:47:24
Jarrod Smith
2019-09-04 08:31:17
Jarrod Smith
2019-09-04 08:32:45
Justin Cupitt
2019-09-04 08:47:24
Doyle Souders
2019-09-06 08:19:59
