Anycubic Photon Printer Owners 造訪社團 » 用戶發文

So, got myself one of the recommended CO-Z ultrasonic cleaners (testing here on a pair of my eyeglasses—I don’t even want to talk about all the schmutz I see wafting off in little cloudy tendrils).

The instructions were...lacking. Poorly translated, and more warnings about how not to use it vs. how to actually use the thing.

My main concern is that the lid doesn’t sit tightly when the basket is in—not to mention rattles like a freight train when it’s running. Am I to assume the lid is not meant to be used during operation, and is more just a cover for periods between uses?

翻譯年糕

After a slightly failed print last night (due to letting the resin sit waaay too long in the vat between prints), I cleaned it all up—including having to change the FEP due to slightly too vigorously scraping the accumulated buildup and punching a hole), filtered my resin and started it again.

The minis came out exactly as intended, but there was still a goopy mass of slightly hardened resin in the center of the FEP. Oddly, it doesn’t seem to have affected the print, but I think it may have accumulated while the sword of the guy on the right was printing (the other figures being complete at that point).

Any thoughts on what may have caused a buildup of half-cured resin in a spot not currently being exposed?

(Pay no mind to the dead looking owl familiar there; gotta switch in some clear resin to print him a stand. Also, apologies for not have photos of the build-up, but I was elbows deep in resin, trying to clean everything up to change out to the clear).

翻譯年糕