Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Mark A. Bishop
2020-01-28 02:43:13

I have an issue with my Photon I hope someone can help me with. After running several good prints all of a sudden my machine shuts down after printing the first layer. If then restarts about 5 seconds later. It did this 6 times in a row with different prints loaded. Any ideas? I got the machine in August.

翻譯年糕

Zena Andreou
2020-01-28 23:50:13

Mark A. Bishop
2020-01-28 23:51:14

Zena Andreou
2020-01-28 23:58:31

Mark A. Bishop
2020-01-29 00:01:10

Zena Andreou
2020-01-29 00:03:22

Mark A. Bishop
2020-01-29 00:07:23

Mark A. Bishop
2020-01-29 00:07:36

原文網址 Mark A. Bishop
2019-11-29 09:04:29

So. Yesterday I asked about all the floppy models and then updated the firmware. All of the bad stuff is gone but now this! Help me, Obi wan kan-hive mind... you’re my only hope!

翻譯年糕

Aaron Wiggins
2019-11-29 09:08:44

Mark A. Bishop
2019-11-29 09:17:45

Aaron Wiggins
2019-11-29 09:28:03

Brad Morris
2019-11-29 09:36:22

Kelly Filgo
2019-11-29 10:13:12

Tauri Icenogle
2019-11-29 11:10:18

Ryan Dunn
2019-11-29 12:34:26

Dave Spray
2019-11-30 11:17:59

Mark A. Bishop
2019-12-01 03:05:00

Dave Spray
2019-12-01 04:34:02

原文網址 Mark A. Bishop
2019-11-28 00:29:04

I've been having issues with garbage prints lately. I've changed the FEP 3 times, levelled and re-levelled. I've replaced the thumb drive. The worst of the misprints is on the right side of the plate. There is a SMALL smudge of IPA on the inside of the LCD screen, front center. Maybe 1/8 diameter. I'm at a loss for what to try next. Suggestions?

翻譯年糕