I'm having a problem with my anycubic, We are printing dungeon tiles and walls for DnD and we are having the bottoms all end up curved. It is happening with the side that is toward the platform. The rafter prints fine but the first layer of the actual object being printed curves up on both sides.
We're using the anycubic aqua blue resin, exposure time is 80s initial for 8 layers, 10s on 1 s off. default settings for most everything else. I'm new to the 3d printing world. We have tried tightening the FEP screen, replacing it, re-zeroing the Z axis, leveling it, and changed exposure time to higher and lower values.
Any advice would be helpful
翻譯年糕
Fred Bey
2019-09-12 12:42:14
Ben Bicakci
2019-09-12 13:28:18
Jeremy LaPlace
2019-09-12 20:55:13
Jeremy LaPlace
2019-09-13 06:58:53
Jeremy LaPlace
2019-09-13 06:59:12
Jeremy LaPlace
2019-09-13 07:11:33
Jeremy LaPlace
2019-09-13 07:26:00
Fred Bey
2019-09-13 07:42:47
Simon Wilson
2019-09-13 08:23:07
