So after a couple failed prints I tried the anycubic photon lattice cube print....and it failed. I'm getting to my wits end here. Not sure what's wrong. I've leveled it twice now so it can only move the paper going out but you can't push it in. I've played with settings from the GitHub so not sure where to go...
翻譯年糕
Hoang Gy
2019-10-02 14:28:15
Heath Carruthers
2019-10-02 14:29:08
Chris LaRose
2019-10-02 14:30:09
Rene Canlas
2019-10-02 14:30:23
James Dodd
2019-10-02 14:30:40
Hoang Gy
2019-10-02 14:31:14
Lyndon Jones
2019-10-02 14:32:38
Kane Wills
2019-10-02 14:33:07
Heath Carruthers
2019-10-02 14:33:59
Kane Wills
2019-10-02 14:35:42
Greg Chapman
2019-10-02 14:44:44
Heath Carruthers
2019-10-02 14:54:13
Kayo Michiels
2019-10-02 15:09:14
Paul Dodd
2019-10-02 22:06:23
Heath Carruthers
2019-10-02 22:09:32
Stefan Giudici
2019-10-03 00:48:23
Daniel Hoke
2019-10-03 06:07:22
Heath Carruthers
2019-10-03 06:08:12
Dustin Oliverius
2019-10-06 02:34:44
