Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Jono Yan
2019-12-16 07:20:38

Hi, I printed this heroforge mini on my anycubic photon and got this really weird layer shift. The layer has only been shifted on the cape and back sword, not the torso or hands. I have never seen this before and I have printed a few heroforge minis before. I checked the .photon file in Chitubox and it al looked fine there...

I did prusa slicer auto supports
Photon file validator/chitubox to address the few remaining islands.

Exposure time 8s
Bottom layers 8
Bottom layer exposure 70s
Off time 6 seconds

翻譯年糕

Jono Yan
2019-12-16 11:59:08

Bob Deblier
2019-12-17 19:01:10

Jono Yan
2019-12-17 19:03:32

Bob Deblier
2019-12-17 19:04:49

原文網址 Jono Yan
2019-11-04 14:24:39

Hey all, I'm new to resin printing. I have an anycubic photon. I have checked the firmware its 4.2.x not 3.4.x. I have tried printing an FDG skeleton mini and part way through the print sticks to the FEP. I am using monocure rapid red resin.

I have tried the settings based on the google doc, and then from the website (longer exposure times, 11 seconds normal, 100 seconds bottom layers). I have re-leveled several times. I am not sure what is going wrong. Could someone please help me? Thank you in advance!

I have tried both the Flint Reid leveling method and the paper one from 3Dprintfarm.

翻譯年糕

Zena Andreou
2019-11-04 14:28:06