How do you tackle suction when your file you are printing is a rectangle that is almost the whole build space and cant be put at an angle? Are there any settings to get around the issue? When my print gets to the yellow part of the model I get really odd sacks of resin trapped. I think the suction is pulled the cured layers a tiny bit and trapping resin as it prints. after 1mm it goes back to normal. This is the bottom of my model so as of now i break the sacs open and drip the resin out. Would like to find a better solution though...
Thanks!
翻譯年糕
El Ner Endem
2019-11-30 16:23:29
Stefan Giudici
2019-11-30 16:23:56
Zena Andreou
2019-11-30 17:17:00
Fred Bey
2019-11-30 18:48:38
Alex Vee
2019-11-30 19:05:21
Richard Clinton
2019-11-30 23:56:38
Richard Clinton
2019-12-01 00:10:53
Alex Vee
2019-12-01 00:14:21
Richard Clinton
2019-12-01 00:40:31
Alex Vee
2019-12-01 01:33:09
Richard Clinton
2019-12-01 02:34:45
Alex Vee
2019-12-01 02:37:01
Sean O'Hayer
2019-12-01 03:19:33
David Rainosek
2019-12-01 03:22:06
Alex Vee
2019-12-01 03:34:05
Alex Vee
2019-12-01 03:42:08
