Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Howard Trumbull
2019-12-30 05:20:23

Woke up this morning to a failed print that had stalled about 50mm up from 0. I found that my photon's X/Y motor had locked up. Not sure why or next steps. ?‍♂️
I've taken the bottom off and found resin had leaked from the build compartment to the electronics compartment. I did find that the hex screws under my resin vat were looser than I'd have liked but the way they hold the fep in I don't imagine that's where it would be leaking. The boards are all untouched and so I've started cleaning up the excess resin that had leaked around the walls and intend on taking off the X/Y motor to confirm there is resin in it but wanted a second opinion. I'm wondering if this X/Y motor issue is what caused the resin to spill or if spilled resin might have killed the motor. How many of you have had to replace the X/Y motor at all? How many of you fill the resin to the top and set your prints to go overnight? What about the loose hex screws under the vat? Are they the smoking guns? Should I reach out to Anycubic, is their support worth messing with? Thanks for the advice!

翻譯年糕

Stephen Mitchell
2019-12-30 07:35:27

原文網址 Howard Trumbull
2019-12-28 10:22:12

Well shoot. I printed these two with my photon using anycubik clear. Any ideas as to what went wrong? I'm using default settings on the resin as far as I know, and then I cleaned off the clear models in 99% IPA, and after curing in UV they came out orange/yellow. ?‍♂️

翻譯年糕