Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Chuck Shurley
2019-12-02 10:00:57

So, I'm getting successful prints for the most part but on slightly larger stuff I'm getting sags like this miniature camper shell. That bottom swell should be parallel to the upper part of the camper. Is it that I'm not exposing the prints long enough or am I not adding enough supports? Appreciate the help for a noob. Thanks!

翻譯年糕

Stefan Giudici
2019-12-02 10:07:46

Chuck Shurley
2019-12-02 11:59:00

Chuck Shurley
2019-12-02 12:35:20

Chuck Shurley
2019-12-02 12:35:35

Brian Todoroff
2019-12-02 13:55:41

Chuck Shurley
2019-12-02 20:23:17

原文網址 Chuck Shurley
2019-11-18 00:30:11

First round of car parts in the printer went...ok. I tried printing eight of these blank front ends twice and each time only the back four came out ok. The four on the front of the plate stuck to the vat and not the plate so they were just square wafers on the bottom of the vat. I don't think it's a leveling problem. I've done the leveling thing each time and it hasn't made a difference. Each time I upped the exposure time and the off time thinking maybe printing slower and longer would help. I do have a dimple in the FEP from another botched print and maybe there's a tension problem. Time for the art part of the art and science to kick in.

翻譯年糕

Mike Syfritt
2019-11-18 14:09:36

原文網址 Chuck Shurley
2019-11-13 08:14:18

Is there any advantage besides speed to rotating your prints 45 degrees from the largest flat side? Do flat pieces like walls turn out less warped? I know it takes longer to print things perpendicular, but I don't mind the time if it uses less resin.

翻譯年糕

Richard Clinton
2019-11-13 08:15:12

David Retske
2019-11-13 08:16:52

Zachary Chin
2019-11-13 08:21:07

Chuck Shurley
2019-11-13 08:41:39

原文網址 Chuck Shurley
2019-11-12 22:16:22

Absolute total noob with nothing more than watching a few YouTube tutorials under my belt. I took my time with the setup and the test print and it seems to have paid off. I was a little nervous after reading some of the horror stories here. Just wanted to encourage the other noobs out there. Didn't mess with any of the settings (although I was tempted) and let it print with right out of the box specs.

翻譯年糕