I see this being asked a ton of times and I thought I was going to be the exception, apparently not.
Got my photon S today, followed all the instructions in the
https://www.anycubic.com/collections/anycubic-photon-3d-printers/products/anycubic-photon-s
got the upgrades upgraded to version 3.4.1 and UI 2.6 but I am getting the "Failed to open File!" message when I try to print anything, photons, pws, whatever.
Can someone help me please?
翻譯年糕
Christian Mendez
2019-12-31 13:19:44
José Fernando Rico Mercado
2019-12-31 13:22:04
Christian Mendez
2019-12-31 13:25:50
Christian Mendez
2019-12-31 13:26:15
José Fernando Rico Mercado
2019-12-31 13:27:07
Christian Mendez
2019-12-31 13:28:16
José Fernando Rico Mercado
2019-12-31 13:30:11
Christian Mendez
2019-12-31 13:31:43
Christian Mendez
2019-12-31 13:33:32
José Fernando Rico Mercado
2019-12-31 13:36:54
Christian Mendez
2019-12-31 13:37:22
José Fernando Rico Mercado
2019-12-31 13:38:59
Christian Mendez
2019-12-31 13:40:52
José Fernando Rico Mercado
2019-12-31 13:41:38
Christian Mendez
2019-12-31 13:43:33
José Fernando Rico Mercado
2019-12-31 13:59:51
Jarin Udom
2019-12-31 14:00:29
Christian Mendez
2019-12-31 14:00:43
Christian Mendez
2019-12-31 14:02:02
José Fernando Rico Mercado
2019-12-31 14:02:27
José Fernando Rico Mercado
2019-12-31 14:02:55
Jarin Udom
2019-12-31 14:03:29
Christian Mendez
2019-12-31 14:05:16
José Fernando Rico Mercado
2019-12-31 14:06:44
Jarin Udom
2019-12-31 14:07:20
José Fernando Rico Mercado
2019-12-31 14:10:04
José Fernando Rico Mercado
2019-12-31 14:10:14
José Fernando Rico Mercado
2019-12-31 14:10:51
Christian Mendez
2019-12-31 14:12:48
Uriah Redden
2020-01-15 10:13:37
