Anycubic Photon Printer Owners 造訪社團 » 用戶發文

I've got a short story, and a need for recommendations.

So, my boss asked me to start working on a project involving 3D printers. He had an old FDM printer that finally bit the dust, and asked me about resin printers. I have been using my Photon since around Christmas and love it. Per said boss's request, the last few work days have consisted of me doing research that I have already done and typing up a "report" of my findings that I already knew about. This is the part that I need recommendations on. I use the Elegoo Grey resin since I print and paint minis, but would need to use a bright colored resin for what I will be printing for my job. We do construction testing so orange, yellow, and red would be the preferred colors. What colorful resins have people had a lot of success with and would recommend that I use?

翻譯年糕

I have seen a few posts about what people have done for curing chambers. This is what I put together. If I remember correctly, it cost me $35-40. I really messed up the spiral of the LED strip, but it still works. I also drilled a hole in the side of the bucket at the bottom, and glued the connector for the LED strip into that hole.

5 gal bucket
Chrome spray paint (considering lining with foil for better reflectivity)
UV LED strip
Cabinet handle (attached to the top of the lid)
Champagne flutes (temporary stands to place prints on, planning on replacing with something else)
Super glue to make the LED strip stick
Outlet timer

翻譯年糕

Hello, I am new to resin printing, and so far it is not going very well... I have already gone through the photonsters website, and tried the suggestions there. For some reason, I cannot get prints to stick to the bed. I got the test print to work once, so I thought I had finally figured it out. Then I tried to print a mini, and it has just gone down hill from there. The bed is perfectly level and tightened down (followed instructions and videos from the website to make sure I did this correctly), I filtered the resin and cleaned everything after each failed print, the FEP is tuned to the recommended Hertz, and the screen functions properly. They sent me the maroon resin instead of translucent green for some reason, so I increased my exposure times by 10 seconds per the website's suggestion. I am at a complete loss here... any other suggestions would be greatly appreciated...

翻譯年糕