Hi all, I'm just getting my photon unpacked and it is apparently a fauxton. I mostly will be using it to print D&D minis. Should I be worried about it being a fauxton instead of an original photon? Does anybody have any advice for using this printer? (keeping firmware up to date, software to use or avoid, tips/tricks etc?)
翻譯年糕
Tim Wolf
2019-12-20 05:15:13
Michael Lee
2019-12-20 05:17:45
Ben Grammarbear
2019-12-20 05:18:44
Ben Grammarbear
2019-12-20 05:19:08
Marcin Jażdżewski
2019-12-20 05:41:04
Lane Shutt
2019-12-20 05:41:35
Ben Grammarbear
2019-12-20 05:59:52
Ben Grammarbear
2019-12-20 06:00:37
Chris Roberts
2019-12-20 06:08:55
Ben Grammarbear
2019-12-20 06:12:57
Martin Philip Lammers
2019-12-20 06:17:18
Randy Shepherd
2019-12-20 06:45:34
David Martin Schulze
2019-12-20 07:01:36
Ben Grammarbear
2019-12-20 07:02:30
Marcin Jażdżewski
2019-12-20 09:15:13
Marcin Jażdżewski
2019-12-20 09:15:44
Jarin Udom
2019-12-20 12:33:19
Randy Shepherd
2019-12-20 21:03:35
Randy Shepherd
2019-12-20 21:06:02
Jasmine Velazquez
2019-12-21 06:27:58
