Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Nick Robinson
2020-01-04 19:16:14

I am contemplating making things that catch fire, namely oil lamps, using my Photon. Has anyone tried this? Does the resin catch fire?

翻譯年糕

Niall Forrester
2020-01-04 19:21:48

Joel Reid
2020-01-04 19:31:35

Rene H Vilhelmsen
2020-01-04 19:43:10

Nick Robinson
2020-01-04 20:06:47

Nick Robinson
2020-01-04 20:14:19

Neil Ramsay
2020-01-04 23:39:47

Mark Wardle
2020-01-04 23:42:41

原文網址 Nick Robinson
2020-01-03 14:34:09

Mando vs Kitten

翻譯年糕

原文網址 Nick Robinson
2019-12-22 16:38:47

I have owned my Photon for a week now and have been busy learning to make successful prints. I have done about four successful prints now and about the same failed. First two as I stuffed the levelling and the last two where the model printed perfectly up to about 90% and then failed. I have noticed that my FEP is being coated with cured resin per the photo (in this case Anycubic Red resin). With the Anycubic Grey resin, I had a similar experience but instead of nice slabs that could be lifted off it was really mottled (dozens of small splotches) and it was hell to clean off. At least with the red, it was in one piece. Is this normal? If not, what would be causing it?

翻譯年糕