Hey Everyone! Just got a new Photon over the holidays and was able to set it up last night and use it.
After some reading online, I think I may have gotten the "Fauxton." I'm using Chitubox to slice but having to do that, then move it to Photon Workshop is becoming quite annoying, as it seems my printer will only read the .pws files. Will not read .photon or .photons
Should I change the firmware with my printer? Or just use both programs for the time being?
翻譯年糕
Vladia M Vittler Woods
2020-01-06 10:08:10
Jason Pedersen
2020-01-06 10:11:07
Haley Shane
2020-01-06 10:11:41
Haley Shane
2020-01-06 10:13:09
Lorne Bixby
2020-01-06 10:22:18
Haley Shane
2020-01-06 10:25:34
Jeremy Babcock
2020-01-06 10:28:40
Haley Shane
2020-01-06 10:30:36
Lorne Bixby
2020-01-06 10:33:58
Lorne Bixby
2020-01-06 10:34:35
Lorne Bixby
2020-01-06 10:35:24
Haley Shane
2020-01-06 10:39:24
Lorne Bixby
2020-01-06 10:45:15
Mark Anthony Vasquez
2020-01-06 10:47:37
Lorne Bixby
2020-01-06 10:49:20
Andrew Burton
2020-01-06 12:09:58
