• 3D列印服務
  • #maker+t=market
  • COSPLAY 3D 建模
  • 1
  • 2
  • 3

Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Daniel Ferguson
2020-02-20 22:37:53

So far a pretty good week of prints - some failures, but my GOOD ratio is getting higher. It's all about the supports and leveling. If you think you need to re-level, you most definitely do.

翻譯年糕

Daniel Ferguson
2020-02-20 22:38:43

Daniel Ferguson
2020-02-20 22:38:48

Daniel Ferguson
2020-02-20 22:38:50

Daniel Ferguson
2020-02-20 22:38:52

Daniel Ferguson
2020-02-20 22:38:53

Daniel Ferguson
2020-02-20 22:39:02

Daniel Ferguson
2020-02-20 22:39:16


原文網址 Daniel Ferguson
2020-02-10 23:41:33

Asking the Hive Mind for assistance.

Trying to use ANYCUBIC RED, based on the latest settings, and nothing is working.

Even upped the first layer count, and exposure time.

Currently up to 100 exposure.

Anybody else have good luck?

Running out of time for a St. Valentine's print before this Friday.

Thanks in advance.

翻譯年糕

Daniel Ferguson
2020-02-10 23:43:30

Luca Cavallari
2020-02-10 23:55:58

Dustin Oliverius
2020-02-11 01:46:00

Nipuna Gunarathne
2020-02-11 22:46:05


原文網址 Daniel Ferguson
2020-01-20 22:18:46

What's the longest time print that you have attempted to print, and was successful?

Me, I can get up to 16 hours, however I get failures at 18-24+ hours.

The 18 hour print attempt, got about 75% complete - then dis-engaged from the plate. Will hollow out more, and add better supports and re-attempt.

The 24 hour print, got about 90% completed - then failed because it ran out of resin. That was my fault as I should have added more overnight.

Does anybody have tips and hints?

翻譯年糕

Bob Deblier
2020-01-20 22:26:35

Bob Deblier
2020-01-20 22:27:19

Jeff Surma Jr.
2020-01-20 22:42:38

Stefan Giudici
2020-01-20 23:23:02


 

討論主題

全不選 常用關鍵字