Okay hive mind, this is a new one for me. Printed an Eevee model, solid, sliced in Chitubox. Everything looked great, until I rinsed it off, and noticed the hole. I didn't put one in the model, didn't dig one out in Chitubox, but I did run the sliced file through the validator.
Any suggestions?
翻譯年糕
Shawn Barnes
2020-01-17 09:21:36
Richard Flanagan
2020-01-17 09:22:12
David Collinson
2020-01-17 09:26:04
Francis X Benz
2020-01-17 09:26:47
Paul West
2020-01-17 09:28:02
Charlie Yoshi Locke
2020-01-17 09:34:26
Gregory Akin
2020-01-17 09:46:42
Tony Kemp
2020-01-17 09:49:39
Phlavio Spr
2020-01-17 09:55:21
Stefan Giudici
2020-01-17 10:47:00
Randall Musgrave
2020-01-17 10:48:43
Randall Musgrave
2020-01-17 10:49:29
Stefan Giudici
2020-01-17 10:50:07
Randall Musgrave
2020-01-17 10:51:19
James Hopwood
2020-01-17 11:28:12
Randall Musgrave
2020-01-17 11:29:56
Joseph Wright
2020-01-17 11:56:14
Gregory Akin
2020-01-17 11:56:47
Randall Musgrave
2020-01-17 11:59:39
Gregory Akin
2020-01-17 12:04:55
Gregory Akin
2020-01-17 12:05:20
Randall Musgrave
2020-01-17 12:05:59
Gregory Akin
2020-01-17 12:11:47
Nipuna Gunarathne
2020-01-17 18:33:01
Randall Musgrave
2020-01-17 19:55:09
Julia Nichols
2020-01-22 20:15:30