Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Joe Tacconelli
2020-03-01 04:46:30

How much smaller should I make the make part of this screw? The female is 7.5mm and I made the male 6.75mm (diameter). After the print I'm not able to get the male all the way in.

Thanks

翻譯年糕

Lorenzo Di Sante
2020-03-01 04:48:12

Rick Driftmyer
2020-03-01 04:52:00

Joe Tacconelli
2020-03-01 04:53:53

Ric Watts
2020-03-01 04:57:07

Gregory Akin
2020-03-01 04:57:30

Stefan Giudici
2020-03-01 05:00:23

Joe Tacconelli
2020-03-01 05:05:23

Joe Tacconelli
2020-03-01 05:12:26

Lorenzo Di Sante
2020-03-01 05:14:50

Ric Watts
2020-03-01 05:16:50

Lorenzo Di Sante
2020-03-01 05:17:44

Antonio Robbins
2020-03-01 08:54:31

Merv Hinton
2020-03-02 06:30:36

Nicolas Tsagarides
2020-03-02 15:54:45

原文網址 Joe Tacconelli
2020-02-21 07:48:08

Does anyone thing I should add supports to this? The hole goes right through

翻譯年糕

Mark Wardle
2020-02-21 07:49:22

Joe Tacconelli
2020-02-21 07:55:12

Mark Wardle
2020-02-21 07:56:06

Mark Wardle
2020-02-21 07:56:43

Joe Tacconelli
2020-02-21 08:06:16

Hugh Jeriolas
2020-02-21 08:06:35

Mark Wardle
2020-02-21 08:07:22

Mark Wardle
2020-02-21 08:09:13

原文網址 Joe Tacconelli
2020-02-17 23:49:48

I was looking to print this on my photon:
https://www.thingiverse.com/thing:2882962
But it says it'll take 12 hours. Is there a way for me to cut down the time of the print. It doesn't have to look pretty. I was thinking of increasing the layer height to 0.1mm, but if I do that I'm assuming I will also need to change the exposure time. Does anyone have any recommendations (either increasing layer height or other means)?
Thanks! 翻譯年糕