The supports were coming out fine, the model was left behind on the FEP. I didnautosupports through prusa slicer and final slicing with chitubox, can anyone tell me where I went wrong?
翻譯年糕
罗西晟
2020-03-29 04:18:26
Euh, 3 seconds exposure is very little... So most likely the supports were still too soft in order to pull the print off the FEP.
Andrew Steele
2020-03-29 04:19:29
Xi-Sheng Luo
I'll try 4 or 5 next time. I'm just worried that with green and a 03 layer I shouldn't go much beyond that.
Fred Bey
2020-03-29 04:20:02
Exposure is way too low. Even for an S, I'd bet. An OG photon was 7.5 seconds for .020 so 3 for .030 is way off.
Andrew Steele
2020-03-29 04:20:28
罗西晟
2020-03-29 04:21:00
Andrew Steele
For your info: Im printing with 8 seconds... For Anycubic Translucent Green.
Room temperature: ~20C
Fred Bey
2020-03-29 04:21:17
still way low, I'd bet. falling off the supports is a sign of under exposure.
Andrew Steele
2020-03-29 04:21:22
Mark Wardle
2020-03-29 04:21:35
way low exposure try the above suggestions 7 or 8 seconds.
罗西晟
2020-03-29 04:22:06
Photon, but the S does not mean that you can cut time in half from the get-go... It's not "that much" faster at curing.
Mark Wardle
2020-03-29 04:22:43
also if you want try my prusa supports for printing miniatures of the base plate
Mark Wardle
2020-03-29 04:23:00
Mark Wardle
2020-03-29 04:23:13
Mark Wardle
2020-03-29 04:23:56
the supports are micro thin. and the model will print off the bed. after adding supports export with the supports. then slice in your fav slicer.
Anders Scot Hudson
2020-03-29 04:28:36
General rule, if the supports are there and the model fell off, too weak or not enough support, if the supports look like they got melted with a plasma hit, it's under exposure.
Anders Jens Ramm
2020-03-29 04:29:57
