Anycubic Photon Printer Owners 造訪社團 » 用戶發文

原文網址 Brenden Van
2020-03-02 11:32:23

Hello again

Sorry for the spam but this is a follow up from my previous posts but shorter version.

Anyone know what happened to my supports? I used photon workshop to slice with the normal default settings.

翻譯年糕

Michael Denney
2020-03-02 11:35:08

Brenden Van
2020-03-02 11:40:38

Michael Denney
2020-03-02 11:41:32

Michael Denney
2020-03-02 11:42:29

Michael Denney
2020-03-02 11:45:57

Brenden Van
2020-03-02 11:58:55

Michael Denney
2020-03-02 12:02:02

Mark Wardle
2020-03-02 12:03:25

Susan Sioux Mercer
2020-03-02 20:57:31

Susan Sioux Mercer
2020-03-02 20:59:41

Brenden Van
2020-03-02 21:08:32

原文網址 Brenden Van
2020-03-01 12:28:11

Hi printing community

I've recently received my photon s and have only had one nice print come out. An issue that occurred was the prints sticking to the fep film as opposed to the plate but after reading posts here, I have releveled it nicely. Thanks. However, a new problem occurs where the supports for the print disappears? I don't know but the images below should tell you my issue.

When I have taken the print out because I cancelled it, the bat does not have any solid bits so I'm wondering what happened to the supports.

The print settings are the basic resin settings are fault but the supports are at medium.

Possible that it could be a corrupted USB stick like the other anycubic as cards that get given to us?

Thanks

翻譯年糕