Anycubic Photon Printer Owners 造訪社團 » 用戶發文

Heya!

Prints keep failing after a new LCD screen was installed. Some parts on the bed print fine, others not, as you can see in the picture. One was made after I stopped to check if everything was okay. Exposure test seems fine.

Never had this issue before the new screen. What may be causing it? (I levelled already, same settings as before with perfect prints, new FEP, nothings works).

thx!

翻譯年糕

Anycubic Photon. What could be going wrong?

Last week I installed a new LCD screen (Anycubic replacement). First prints went well, no fails. The last couple of days I had more and more failed prints: no print in the middle, no print on the left side of the bed etc.

I tried the usuals: cleaning, levelling… Today I wanted to test the printer again: test print of some head in different locations. And the results are more terrible than before.

With my old LCD screen I didn't have this problem, same resin, same settings: 0.04mm, 6s exposure, 7 bottom layer, 80s exposure.

Extra clue might be the apparent loss of detail before and after the new screen.

翻譯年糕

Heya!

Perfect prints for a few months, but then everything went wrong.

Had the same issue last week (see pics), cleaning, leveling, changing FEP film fixed the issue. But today it started again: my entire miniature changes into one big rectangle. Both pics were stopped mid print, as it obviously failed. What goes wrong?

Second picture is the intended print, which is my second test of today. Third picture is the first fail of today, I wanted to print a bigger miniature.

Thanks!

翻譯年糕