Does anybody know why this is happening when using Monocure? Seems to occur on longer print times. Its not a leveling issue as it builds up after a couple of hours into the print
翻譯年糕
Thomas McConnell
2020-03-30 10:43:59
Never had this issue. Used 10l of it
Dave Smith
2020-03-30 10:44:17
Martin Martinez
2020-03-30 10:49:08
Dave Smith
2020-03-30 10:49:40
Emre Güneş
2020-03-30 10:50:04
ı thınk bed level problem
Cesar Gil
2020-03-30 11:00:50
Brendan Wood
2020-03-30 11:03:45
Increase the Base exposure time in whatever program you are using to slice. It could be that the bottom layers aren't sticking to the build plate enough.
Martin Martinez
2020-03-30 11:41:11
nah, these are building up on non print areas.Starts printing fine and builds up, seems light is bleeding out
Brendan Wood
2020-03-30 11:42:21
Gotcha. Looks just like a pancake from a much more common problem. Gotta say what's wrong even with a picture lol
Jaco Norchie Nortje
2020-03-30 12:10:20
Scott Pavlich
2020-03-30 12:22:17
Is that left behind but you are still getting a print? Most likely your screen is dying
Martin Martinez
2020-03-30 12:56:25
Scott Pavlich
yea getting left behind and still getting a print (crap print). Seems like yes, screen about to go
Scott Pavlich
2020-03-30 13:12:47
Martin Martinez
Yep....it’s not a leveling issue that’s for sure. Every time one of my photons has that problem I know it’s time to replace the screen